EPDM Peel & Stick Pipe Boot

EPDM Peel & Stick Pipe BootEPDM Peel & Stick Pipe Boot EPDM Peel & Stick Pipe Boots are used to create a waterproof seal between the roof deck and protruding pipework. After installing the roofing membrane place the pipe boot in position by sliding it over the drain or pipe. You will need to cut the top to the required diameter of the propruding pipe. Draw a circle around the base of the Pipe Boot to mark where the primer needs to be applied. Remove boot and apply QuickBond

EPDM Peel & Stick Pipe Boot

EPDM Peel & Stick Pipe Boots are used to create a waterproof seal between the roof deck and protruding pipework. 
After installing the roofing membrane place the pipe boot in position by sliding it over the drain or pipe. 
You will need to cut the top to the required diameter of the propruding pipe. 
Draw a circle around the base of the Pipe Boot to mark where the primer needs to be applied.
Remove boot and apply QuickBond primer to the EPDM/surface underneath
Wait until primer is touch dry and then re-install the pipe boot positioning over the pipe and onto the roof membrane. 
Smooth down the join with a seam roller
Roll back the top of the boot and apply water cut off mastic around the pipe. Then roll back up over the water cut off mastic to seal.

If you have any queries, please get in touch with our friendly team on 01392 927729 or email [email protected]. You can also check out our Roof Calculator that estimates all the materials you will need for your rubber roofing project.